Tetrion TFL400 Make Good Fix A Leak 400m

Tetrion Make Good™ Fix A Leak- Simply spray to fill & seal leaks and cracks. Ideal for fixing draughty window frames, skylights, chimneys, waste pipes & much more

• Flexible liquid rubber
• Bonds to all types of metal, wood, plastic, brick, concrete, PVC
• Watertight finish, prevents leaking
• Can be overpainted

Tetrion Make Good™ Fix a leak is liquid rubber in a can! Fix a leak provides a rubberised coating which fills and seals fine leaks and cracks. Fix a leak provides a tough, water tight, yet flexible seal, which can stop leaks in pipes, gutters, skylights, seal draughty window frames and has many more uses. It can be used on roof lights, ducting, vinyl, plastic, metal, masonry concrete, plant pots, gutters and downspouts. It is UV resistant and can be overpainted. It works impressively in waterproofing surfaces, especially on surfaces that are in direct contact with seepage water, moisture and non-pressurised liquid or water.

Tetrion Make Good™ Fix a leak creates a barrier coating to prevent moisture penetration, reducing rust, corrosion and other problems associated with moisture ingress.

Tetrion Make Good™ Fix a leak is high-build and produces a durable barrier, yet still giving good flexibility over wide temperature changes and bright sunlight.

Tetrion Make Good™ Fix a leak offers the following features:

• Rubberised protective proofing formula
• Easy to use aerosol format
• High build, tough, flexible
• UV resistant
• Seals fine leaks & cracks
• Use on roof lights, ducting, vinyl, plastic,metal masonry
• Also on concrete, plant pots, gutters & downspouts
• Dries to a low gloss finish

Application:

1. Remove all loose dirt & debris from the area to be coated. If required, clean and thoroughly dry the area.
2. Remove any previous surface coatings with wire brush & abrasive paper.
3. Lightly sand with a finer abrasive paper to give a good key and re-clean & dry.
4. Shake aerosol can vigorously for 2 minutes minimum.
5. Firstly test spray on a small inconspicuous area, to check spray rate, pattern and compatibility.
6. Apply in short, even, light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry in between coats.
7. If spray button clogs, invert can and spray to release.
8. Clean overspray and spillages before coating dries, with white spirit-type solvent.

Supplementary Information.

• Ideal for fixing draughty window frames, skylights, chimneys, waste pipes & much more
• Bonds to all types of metal, wood, plastic, brick, concrete, PVC
• Watertight finish, prevents leaking
• Can be overpainted